ArmorPoxy

I purposely waited to write a review on this product because I wanted to see how it held up first, the product was installed on a freshly ground surface, first coat went well, second coat also went well, job looked nice when I was done. Unfortunately after the first 100 degree day It started bubbling in different areas and peeling. It cost me over 1500 in materials, I would not recommend this product to anybody at this point. I have not complained to the company as I feel they would have any reason to say that it’s my fault.

Very disappointed with the customer service and materials provided. Armorpoxy shipped the wrong installation instructions with my kit. Despite acknowledging their mistake, they have offered no real solution to resolve moving forward. This will result in significant labor and material cost at no fault of my own. I now have a 1/2 finished garage floor. I advise other customers to purchase their materials from other Company’s who are truly customer centric and willing to own and resolve mistakes when they occur.

Do not buy. Does not work in the Bay Area as manufacturer said we should have installed when 70-75 degrees and less than 50 percent humidity. Bought a cheaper product for a fraction on the cost at Home Depot. But cost big $$$ to sand off the floor. Nightmare.

Had the worst experience with this product. 20 dry time is insane. Any corrections any mistakes you’re screwed. The kid did not come with a primer only etching. The primer would’ve saved my floor. The floor was prepared properly and etched the first layer very trends loosened. You could see the gray cement floor underneath requiring a second coat. To do a second coat you have to wait for the first coat to completely dry and since it’s shiny, I was told to sign down very well, which I did. Didn’t work. The second layer dissolved the first layer and peeled right off in certain areas. Now, since you only have 20 minutes, couldn’t patch up the damage with primer since the epoxy would dry in the bucket. Absolute nightmare I’m gonna leave it as it is now I’m probably gonna have to redo the entire floor again once it starts peeling up. Do not buy the fast drying epoxy and absolutely use a primer in between coats and especially to the bear cement.

Do not buy the 20 minute dry time poly aspartic floor coat coating. You cannot properly code a floor in 20 minutes. It is impossible even with two people. No time to make adjustments and if you make it a mistake, you’re screwed. You will ruin your floor. I bought the kit it didn’t come with a primer so I thought I didn’t need a primer. Even though I thoroughly power washed and etched my cement floor , when applying a second coat it peeled off the first. I specifically called the company to ask what I need to do to the first code in order to apply a second or third. They said lightly a sand. Nope you need to prime. Sending there nothing able peel. I am so pissed. I spent so much money for shitty floor.